Table of Contents
Advertisement
3-6 Making Corrections for Printing and Cutting
When printing is followed by cutting, the cutting line may be displaced from the printing margin. If this happens, use the
[PRINT-CUT ADJ.] function on the menu to align the start points for printing and for cutting.
Before you run [PRINT - CUT ADJ.], run [ENV. MATCH]. For more information about how to adjust this, see "1-5 Switching
On the Power for the First Time -- Step 3: Match the Machine to the Environment Where Installed."
Adjusting Automatically
Load some media and press the [SETUP] key.
1
Press the [MENU] key, and press the [
2
to make the following screen appear on the dis-
play.
3
Press the [
] key to make the following screen
appear on the display.
Press the [
] key to make the following screen
4
appear on the display.
Press the [ENTER] key to print crop marks and
5
read the square mark automatically.
6
When the following message appears,
automatic adjustment is finished.
Depending on the type of media, it may not be possible to perform correction automatically. If this happens, read in the offset
value from a test pattern and align the positions for printing and cutting. For information on how to read an offset value from a
test pattern, see the next section, "Adjusting Manually."
The SETUP LED lights up
] key
NOW PROCESSING...
While automatic adjustment is in progress, the
following message appears on the display.
PRINT-CUT ADJ.
Chapter 3 - A Wide Variety of Operations
MENU
PRINT - CUT ADJ.
PRINT - CUT ADJ.
TEST PRINT
PRINT - CUT ADJ.
AUTO
Rear
Front
Square mark
COMPLETED!!
69
Hide quick links:
Advertisement
Table of Contents
