How To Replace The Blade - Roland SolJet PROII SC-540 User Manual

4-6 How to Replace the Blade

Do not touch the tip of the blade with your fingers.
Doing so may result in injury, and the cutting performance of the blade will be impaired.
Press the [MENU] key, and press the [
1
to make the following screen appear on the dis-
play.
2 Press the [ENTER] key to make the following
screen appear on the display.
When the screen shown in the figure appears, the printing
carriage simultaneously moves to the left.
3 Loosen the tool securing screw in the figure,
remove the blade holder from the cutting
carriage.
Remove the old blade.
4
5 Replace with a new blade.
Support the tool-securing screw from below and
6
install the blade holder.
Insert the blade holder until the collar is flush with the
carriage.
Tighten the tool securing screw.
7
Tug the blade holder upward to make sure it does not
come loose.
Close the front cover, and press the [ENTER]
8
key.
Chapter 4 - Maintenance
84
] key
Blade holder
Old blade
Push-pin
Blade holder
New blade
Screw
MENU
REPLACE KNIFE
FINISHED ?
Screw
Press the push-pin
It snaps into place with
an audible click.