What To Do If The Printing Carriage Does Not Operate - Roland SolJet PROII SC-540 User Manual

What to Do If the Printing Carriage Does Not Operate

During operation, if for some reason the printing carriage does not return to the standby position, then following the
procedure, cap the printing heads, and contact the your authorized Roland DG Corp. dealer or service center.
If the printing carriage is allowed to stand for a prolonged period with the printing heads uncapped (that is with the
printing carriage over the platen), the heads may become clogged or even damaged.
Capping the Printing Heads
1 Make sure the main power is switched off, then
open the cover on the right side of the machine.
2 Open the front cover and move the printing
carriage to the standby position by hand.
Insert the oval end of the pipe included with the
3
machine into the hole in the bottom of the ma-
chine, then rotate the pipe.
The cap unit rises.
Align the guides at the two ends of the cap unit
4
with the guides at the two ends of the printing
carriage.
Turn the pipe more bring the cap unit close to
the printing carriage.
Printing carriage
Guides
Chapter 6 What to Do If...
6-1 What to Do If...
Standby position
Pipe
Guides
Cap unit
107