Installing 6Kpm Cards In The Magnum 6K8-Series - GarrettCom Magnum 6K8-Series Hardware Installation And User's Manual

Magnum 6K8-Series Industrial Field Switch
Figure 3.6.1d: Removing Face Plate
Carefully remove the PM screen plate
using finger or small screw driver to
come out easily as shown in Fig
3.6.1d on the right. Just be careful on
the LEDs placed both side and hold
the face plate tightly. There are no
screws used on holding the screen
.
face plate
3.6.2

Installing 6KPM Cards in the Magnum 6K8-Series

Only one front-mounted 6KPMV Module may be installed in one Magnum
6K8-Series Field Switch unit. Follow these steps to install a 6KPMV.
Remove top chassis cover. See procedure in Section 3.6.1 above.
Step 1.
Fig 3.6.2a A Magnum 6K8 unit with main board(motherboard) only
www GarrettCom com . .
Installation and User Guide 03/06)
Once opened all the four retaining screws the
front cover can be removed easily as shown in Fig
3.6.1d. on the left.
Step 2.
board (as shown in fig. 3.6.2b)
on the chassis built in stand off
(female) provided at the front of
the 6K8-Series Main Board. To
place the Granddaughter board
on the chassis, as shown in
34
Figure 3.6.1d: Removing
PM screen Plate
Place Granddaughter