3.6.1 Preparation For Installing And Removing 6Kpmvs From 6K8'S - GarrettCom Magnum 6K8-Series Hardware Installation And User's Manual

Magnum 6K8-Series Industrial Field Switch
referred to as "6KPMV" for convenience in describing port module installation.
Magnum 6K8-Series Switches are normally received from the factory with all
required 6KPMV modules installed. There may be situations where 6KPMV cards need
to be added or replaced. In cases where additional 6KPMV cards are needed, the
faceplate for an available front-mounted slot must be removed. The following procedure
describes this operation. The pictorial view of the hardware assembly can be seen here-
http://www.garrettcom.com/Pictorial/6k8_pictorial.pdf

3.6.1 Preparation for Installing and Removing 6KPMVs from 6K8's

Caution- Avoid Static Discharge: The port modules (like most electronic
equipment) are sensitive to static discharge. Use proper ESD measures when
handling port modules.
Make sure the 6KPMV Card package has all necessary accessories and use the
Step 1.
proper tool to install it properly. Each 6KPMV Card package, for field
installation contains (Daughterboard (Bigger) and Granddaughter board
(smaller), three 5/8 stand offs for Granddaughter board, 6 standoff for daughter
Board, nine #4-40x3/8 Pan-Head screws along with Front panel face plate
package.
NOTE: Every 6KPMV Card package comes with their matching Daughter and
Granddaughter board. The copper 6KPMV card should not work properly if mixed
with other Fiber combo 6KPMV card packages. Always install the PM module
separately one by one to avoid the mixing.
Do not change the Blue color DIP Switch setting ever! Leave it at factory default.
Step 2. Remove Chassis Cover
www GarrettCom com .
STOP!!!
Be sure the power cord is unplugged
from the chassis before attempting to remove
and/or replace any PM cards.
Failure to do so may result in damage to the unit
and will void the warranty.
.
Installation and User Guide 03/06)
32