GarrettCom Magnum 6K8-Series Hardware Installation And User's Manual page 9

Magnum 6K8-Series Industrial Field Switch
DC Power Supply (Options)
-48VDC Power Input Voltage : -36 to -70 VDC
24VDC Power Input Voltage : 18 to 36VDC
125VDC Power Input Voltage : 88 to 300VDC
5VDC Power Input Voltage : (+) or (-) 5%
Std. Terminal Block : " -, GND, + "
Power Consumption: same as for AC models, see above
For DC internal power supplies at –48VDC, 24VDC and 125VDC,
including Dual Source options (
DC input sources are interrupted)
Per-port MDI or MDIX on RJ-45
The copper daughter board has MDI-MDIX Auto-crossover on all the RJ-45
ports., and eliminate the use of cross-over cable between the devices. Also
port-specific user settings (such as FDX or HDX, copper 10/100 speed) can
be fixed using software commands.
Mountings:
Vertical mounting only Suitable for wall or DIN-Rail mounting
Agency Approvals
Magnum 6K8
UL listed (UL60950), cU, CE
Emissions meet FCC Part 15 Class A
IEEE P1613 Environmental Standard for Electric Power Substations
IEEE 61850 EMC and Operating Conditions, class C for Electric Power
Substations
NEMA TS-2 and TEES for traffic control equipment
Note: These products are tested and approved under IEC61850 for use in Class
C sheltered locations where neither temperature nor humidity are controlled.
The equipment needs to be protected against solar radiation, rainfall, other
precipitations and wind. UL has not approved these products for Annex-T
outdoor use.
Warranty: Three years, per UL 60950 temperature rating
Email
sales@GarrettCom.com
www GarrettCom com . .
Installation and User Guide 03/06)
for continuity of operation when either of the
, see Appendices B and C.
for details.
4
Made in USA