Installing 6Kpm Cards In The 6K32F Series - GarrettCom Magnum 6K32F Installation And User Manual

Magnum 6K32F/FR/FC/FRC Managed Switch Installation and User Guide (05/08)
Looking down into the Magnum 6K32F Series unit, notice that there are individual PM
installation spaces and female latch (white) connectors provided on the far right side of
the main board along with four stand-off's for 6KPM card position. (See Figure 3.5.1c).
Figure 3.5.1c: Magnum 6K32F Series modular slot side (front-right side), without
chassis cover
3.5.2 Installing 6KPM Cards in the Magnum 6K32F Series
Up to four front-mounted 6KPM cards may be installed in one Magnum 6K32F
Series Managed Switch unit. Follow these steps to install a 6KPM.
Step 1. Remove top chassis cover. See procedure in Section 3.5.1 above.
Step 2. Placed Granddaughter board (as shown in fig. 3.5.2a) on the chassis built in
stand off (female) provided at the front of the 6K32F Main Board and screw
down tightly with the three 5/8 stand-off (male) on the top of the
Granddaughter board. The 5/8 stand offs are used to place the daughter board
on the top of the granddaughter board and latch it securely.
Fig 3.5.2a: Granddaughter Board placed in modular slot and secured with three
5/8" stand-offs as shown with arrow mark
www GarrettCom com . .
38