Entering Data By Means Of The Lcd Keypad - Satel INTEGRA Plus User Manual

14
[52] All events
[6] Set time
[7] System state
[8] Outputs control
[9] Service mode
[0] Downloading
[01] Start DWNL-RS
[02] Finish DWNL-RS
[03] Start DWNL-MOD.
[04] Start DWNL-TEL
[07] ETHM-1 – DloadX
[08] ETHM-1 – GuardX

5.3.4 Entering data by means of the LCD keypad

Data are saved to the control panel if you press the
also available, whose function is exactly the same). The
without saving any changes.
Described below are general rules for entering data, however they may be different as
regards some functions.
Selection from the single-choice list
Shown in the upper line of display is description of the function, and in the lower one – the
currently selected item. You can scroll through the list of items, using the direction keys: 
(down) and  (up). The  and  keys are not used.
Selection from the multiple-choice list
The functions that allow you to make multiple choice can be identified by an additional
symbol situated at the right-hand side of the display:
– displayed item is selected / option is enabled;
– displayed item is not selected / option is disabled.
Press any numeric key to change the currently displayed symbol to another one. To scroll the
list of items, use the  (down) or  (up) key.
For some functions, pressing the  or  key will switch the keypad into the graphic
programming mode. The
status of up to 32 items available in the given function (these can be e.g. zones, outputs,
timers, etc.). Additionally, in case of zone bypassing, the
the cursor to the right, and the  key to the left. If the list of items is longer than 32, pressing
the  key when the cursor is placed over the last item will display the next list, and pressing
the  key when the cursor is placed over the first item will display the previous list (see also
description of the
within 3 seconds will have the following effect:
000 - the symbol will be displayed at all available items;
111 - the symbol will be displayed at all available items;
222 - reversal of the selection made: the
the symbol was displayed, and the
On pressing the  or  key, the keypad will return to the text mode.
and symbols are used to present on the display the current
LEDs, p. 7). Pressing the key 0, 1 or 2 three times in the graphic mode
User Manual
key (in some keypads, the
symbol is used. The  key moves
symbol will be displayed at all items where
symbol where the
key enables exiting the function
symbol was displayed.
SATEL
key is