Satel INTEGRA Plus User Manual page 2

WARNING
Before you start using the control panel, please read carefully this manual in order to avoid
mistakes that can lead to malfunction or even damage to the equipment.
Changes, modifications or repairs not authorized by the manufacturer shall void your rights
under the warranty.
The INTEGRA Plus control panels should only be connected to the analog subscriber lines.
Connecting its telephone circuit to a digital network (e.g. ISDN) may cause damage to the
equipment. In case of changing the analog line to the digital one, it is necessary to contact
the alarm system installer.
Pay special attention if the telephone line used by the control panel is frequently busy and/or
failures are reported, concerning the line and/or monitoring. Report such situations to the
alarm system installer immediately.
To ensure adequate protection, the alarm security system must be in good working order,
therefore SATEL recommends that it be regularly tested. The control panel is equipped with
a number of self-diagnostic functions which, when properly configured by the installer, ensure
control over correct functioning of the system.
The alarm security system cannot prevent burglary, assault or fire from happening, but it
guarantees that in case of emergency measures will be taken to reduce the possible damage
(the alarm will be signaled optically and acoustically, appropriate services will be notified,
etc.), which may deter the potential burglars.
The SATEL's goal is to continually upgrade the quality of its products, which may result in
alterations of their technical specifications and firmware. The current information on
the introduced modifications is available on our website.
The declaration of conformity may be consulted at www.satel.eu/ce
Factory default codes:
Service code: 12345
master (administrator) code for partition 1: 1111
The following symbols may be used in this manual:
- note;
- caution.
Please visit us at:
http://www.satel.eu