Starting Functions; Menu Shortcuts - Satel INTEGRA Plus User Manual

SATEL
Station 2B test
Messaging test
Answering test
Prox. card test
CA-64 PTSA test
View masters
Keypad name
File in DloadX
Panel version
STM prg.version
IP/MAC ETHM-1
Modules version
Time synchron.
Service access
Open door
Outs control
Service mode
Take SM over
Downloading
Start DWNL-RS
Finish DWNL-RS
Start DWNL-MOD.
Start DWNL-TEL
ETHM-1 – DloadX
ETHM-1 – GuardX

5.3.2 Starting functions

1. Using the  and  keys, find the required submenu or function. The currently selected
submenu or function is indicated by the arrow ( ) on the left-hand side.
2. Press the  or
start the function.

5.3.3 Menu shortcuts

You can use shortcuts for quick access to some menu elements (submenus, functions).
Press the suitable digit key (or combination of keys) to enter a submenu or start a function.
Shown below is the list of submenus and functions available by using shortcuts. The
shortcuts are shown in square brackets.
[1] Change own code
[2] Users
[21] New user
[22] Edit user
[23] Remove user
If the installer is not authorized to edit the users, the shortcuts beginning with the digit
2 will allow the installer to start the function from the M
[4] Zone bypasses
[41] Inhibit
[42] Isolate
[5] Events
[51] Selected events
INTEGRA Plus
start test transmission to station 2 – backup phone number
start messaging test
display information on answered tel. call
check proximity card number
start mimic board test
view master users
display keypad name
display inf. on D
display information on control panel firmware version
display information on the STM processor program version
display inf. on ETHM-1 module IP address and MAC number
display information on module firmware version
start time synchronization
set installer access time
open selected door controlled by system
control outputs
start service mode
take over service mode
start local programming
finish local programming
start communication via external modem
start communication via 300 bps modem
start communication via Ethernet with D
start communication via Ethernet with G
key to enter the submenu (the  key allows to exit the submenu) or
X program file with control panel data
LOAD
submenu.
ASTERS
X program
LOAD
X program
UARD
13