Satel INTEGRA Plus User Manual page 22

20
CA-64 PTSA test – allows to test the mimic board.
View masters – available to the administrator. It makes it possible to check in which
objects the master users are created.
Keypad name – allows to check the given keypad name.
File in DLOADX – displays the date and time of writing the data to the control panel by
means of the D
Panel version – displays information on the control panel firmware version.
STM program version – displays information on the program version of the processor
used to operate the control panel zones and power supply unit.
IP/MAC ETHM-1 – displays the IP address and MAC number of the ETHM-1 module
connected to the control panel.
Modules versions – allows to check the firmware versions for devices connected to the
control panel communication buses.
Time synchronization – allows to manually start synchronization of the control panel
clock and the time server. It applies to the control panel to which the ETHM-1 module is
connected. The address of time synchronization server must be programmed in the
control panel.
The function is unavailable, if the time synchronization is running. Automatic time
synchronization takes place every day at 05:30.
Service access – available to the master user (administrator). Allows to program the time
period of installer access to the alarm system. The time is programmed in hours.
Programming the value 0 means the installer will have no access.
Open door – allows to unlock the door controlled by the alarm system (modules executing
the access control functions) or activate the 101. C
Outputs control – allow to control the devices connected to the MONO
R
EMOTE SWITCH
p. 33).
CONTROL
Service mode – available to the installer. Initiates the service mode.
Take SM over – available to the installer. If the service mode has been initiated from another
keypad, it can be "taken over", i.e. the service menu can be displayed on the keypad, on
which the T SM
AKE
Downloading – the following functions are available in the submenu
Start DWNL-RS – available to the installer. Enables the control panel to be programmed
locally by means of the D
Finish DWNL-RS – available to the installer. Ends the local programming of control panel.
Start DWNL-MOD. – enables remote programming through an external modem (analog,
GSM or ISDN) by means of the D
Start DWNL-TEL – enables remote programming through the built-in 300 bps modem,
using the D
LOAD
ETHM-1 – DloadX – enables remote programming through the Ethernet (TCP/IP) by
means of the D
newer) must be connected to the control panel.
ETHM-1 – GuardX – enables remote operation and administration through the Ethernet
(TCP/IP) by means of the G
1.03 (or newer) must be connected to the control panel).
X program and the name of file with control panel data.
LOAD
, S and S
HUTTER UP
function has been started.
OVER
X program.
LOAD
X program.
X program. The ETHM-1 module with firmware version 1.03 (or
LOAD
UARD
User Manual
ARD READ
type outputs (see: section O
HUTTER DOWN
X program.
LOAD
X program. The ETHM-1 module with firmware version
– type outputs.
EXPANDER
, BI
SWITCH
SATEL
,
SWITCH
UTPUTS