Lan Config - ATCOM AT530P User Manual

AT530P User Manual
setting and the setup are correct.
Notice: If user accesses the IP phone through WAN port. He/She should use the new IP address to
access the IP phone when the WAN port address was changed.
2.3.2

LAN Config

Bridge Mode: Enable this option to switch to bridge mode. IP phone won't assign IP for its
LAN port in bridge mode and its LAN and WAN port will be in the same network. (This setting
won't take effect unless you save the config and reboot the device)
IP Netmask: Set the IP and Netmask for the LAN
DHCP Server: Enable DHCP service in LAN port
NAT: Enable NAT.
9/49