Advance Sip Settings - ATCOM AT530P User Manual

AT530P User Manual

2.5.6 Advance SIP settings

This page is used to set the private sip server, stun server, and back up sip server
information.
STUN Server setting:
STUN Server Addr: configure stun server address;
STUN Server Port:
STUN Effect Time:
Enable SIP STUN:
Enable PRACK: Whether to make gateway or IP phone support Prack function in SIP , we
suggest you keeping default setting
Enable Keep Authentication: registering signal together with the authentication information.
If enable it, the server will confirm the registering and send back the confirmation massage
directly instead of requesting the terminals to send authentication information if needed.
Auto Detect Server: Whether to enable the function of auto detecting the server. With this
function your ATA and IP phone will send information to auto detect the server at every period
of time. If find the server is not available it will try to register the server again.
Enable Session Timer：Whether to enable te RFC4028
Signal Encode: Wherther to enable the signal encrypt
Rtp Encode: Whether to enable the voice encrypt
Enable Private Register: Whether to enable the second SIP Server to register
Please refer to SIP_Config for the setting for how to set the public alter server.
User can register two sip servers: public sip server and private sip server.these two sip servers are
independent from each other and running in the same time.
For how to configure private sip server. Please refer to SIP_Config
Enable URI Convert: transfer the # into %23 when sending URI
configure stun server port default 3478
stun detect NAT type circle, unit: minute.
enable/disable stun.
17/49