Assigning Initial Router Parameters - Avaya C360 Installation And Configuration Manual

In order to...
Specify the VLAN on which an
IP interface resides
Use this command before
configuring VLAN-oriented
parameters, when there is more
than one interface on the same
VLAN
Display information about the IP
unicast routing table
Display information for an IP
interface
Display the status of ICMP error
messages
Delete a Layer 2 Router
interface

Assigning Initial Router Parameters

To configure the initial router parameters perform the following via the CLI:
1. Type set device-mode router and press Enter.
You will be prompted to reset the switch.
2. Type y.
Wait for the switch to restart and for the CLI prompt to reappear.
3. Type show device-mode and press Enter to ensure that the module is in router mode.
Tip:
Assign the stack IP address as described in
Tip:
page 64 before you assign the Initial Router IP address.
4. To access Router commands from the Master module, type the command session
<module number> router where <module number> is the location of the router
module in the stack, and press Enter.
The command prompt changes from C360-N> to Router-N#> where N is the number of
the router in the stack (see
5. Type configure and press Enter. The prompt Router-N(configure)# appears.
Use the following command...
ip vlan/ip vlan name
enable vlan commands
show ip route (Layer 3)
show ip interface
show ip icmp
clear vlan
SNMP Support).
Assigning C360 IP Stack Address
Issue 1 July 2006
IP Configuration
2 of 2
on
163