Spanning Tree Protocol Cli Commands - Avaya C360 Installation And Configuration Manual

Spanning Tree Protocol CLI Commands

The following table contains a list of CLI commands for the Spanning Tree feature. The rules of
syntax and output examples are all set out in detail in the Reference Guide for the Avaya C360
Converged Stackable Switch, 10-300506.
In order to...
Enable/Disable the spanning tree
application for the switch
Set the bridge priority for
spanning tree
Set the RSTP bridge spanning
tree max-age parameter
Set the RSTP bridge hello-time
parameter
Set the RSTP bridge
forward-delay time parameter
Select between STP operation or
RSTP switch operation
Display the bridge and per-port
spanning tree information
Set the TX hold count for the STA
Add a port to the spanning tree
application
Remove a port from the spanning
tree application
Set the port spantree priority
level
Set the cost of a port
Set the port as an RSTP port
(and not as a common STA port)
Display a port's edge admin and
operational RSTP state
Use the following
command...
set spantree
set spantree priority
set spantree max-age
set spantree hello-time
set spantree forward-delay
set spantree version
show spantree
set spantree priority
set port spantree enable
set port spantree disable
set port spantree priority
set port spantree cost
set port spantree
force-protocol-migration
show port edge state
Spanning Tree Protocol
1 of 2
Issue 1 July 2006 131