Driver Installation And Advanced Settings; Lan Driver And Proset; Graphics Accelerator Driver - NEC Express5800/R120b-1 User Manual

Express5800/r120b-1
Table of Contents

Advertisement

E-24 Installing Windows Server 2008

DRIVER INSTALLATION AND ADVANCED SETTINGS

This section describes on how to install and setup various standard drivers mounted on the device.
For the information on installing and setting up the driver that is not described in this section, please
refer to the document attached to the driver.

LAN Driver and PROSet

Please refer to Chapter 5 "Installing and Setting Device Drivers" for Windows Server 2008 to install
and setup LAN driver and PROSet.

Graphics Accelerator Driver

If you utilize standard graphics accelerator drivers, update your system with NEC
EXPRESSBUILDER DVD-ROM attached to your system.
Standard graphics accelerator drivers will be installed automatically.
NOTE:
The graphics accelerator driver is supported only on a server running a
full installation. Use VGA on a server running a Server Core
installation.
Please follow the following procedure when you want to reinstall the driver individually.
1.
Insert the NEC EXPRESSBUILDER DVD-ROM into the optical disk drive.
If the autorun menu is displayed, close menu screen.
2.
Click Start menu, point to [Programs], [Accessories] and click [Windows Explorer].
3.
Run "Install.bat" in the following directory.
– Windows Server 2008 64-bit (x64) Edition:
\017\win\winnt\ws2008x64\video
– Windows Server 2008 32-bit (x86) Edition:
\017\win\winnt\ws2008\video
4.
Follow the message to continue the installation.
If the dialog message "Digital Signature could not been found." appears, select [Yes] to
continue.
5.
Remove the NEC EXPRESSBUILDER DVD-ROM from the optical disk drive, restart the
system.
<Windows Server 2008>

Advertisement

Table of Contents
loading

Table of Contents