Table of Contents
Advertisement
DRIVER INSTALLATION AND ADVANCED SETTINGS
This section describes on how to install and setup various standard drivers mounted on the device.
For the information on installing and setting up the driver that is not described in this section, please
refer to the document attached to the driver.
LAN Driver and PROSet
The LAN driver and PROSet have been installed automatically while your system was being
updated in the previous section.
NOTE:
system from a local console using an administrator account. Remotely
changing the settings by using the operating system's remote desktop
feature is not supported.
Using N8104-125 Adapter after System Update
To use the N8104-125 Adapter after updating your system, you must first uninstall the LAN driver
and PROSet, and then update your system with the N8104-125 Adapter connected.
For a server running a full installation
1.
Remove a team of network adapters.
NOTE:
addresses) of the standard and optional adapters teamed for network
redundancy.
Configure the settings after reinstalling the LAN driver and PROSet.
To remove the team, see "Adapter Fault Tolerance (AFT)/Adaptive
Load Balancing (ALB)".
2.
In [Control Panel], click [Uninstall Program].
3.
Double-click [Intel(R) Network Connections 13.2.8.0].
[Intel(R) Network Connections (Remove Options)] appears.
4.
In [Remove Options], click [Remove].
[Intel(R) Network Connections - Remove Software] appears.
5.
Select [Yes].
The uninstallation starts automatically.
6.
When [InstallShield Wizard Completed] appears. Click [Finish].
7.
Restart the system.
To change the LAN driver and PROSet settings, log on to the
Before you remove, note down the current settings (e.g. IP
Installing Windows Server 2008 D-29
Advertisement
Table of Contents
