Table of Contents
Advertisement
The procedure to set PAE option
If your 32-bit system has a memory capacity in excess of 4GB, setting PAE option will enable the
system to be installed with over 4GB of memory.
IMPORTANT: "PAE option" is not supported on Windows Server 2008
Standard.
In Windows Server 2008 system, the PAE option can be set by using Bcdedit.exe.
The setting procedure is as follows.
1.
Click [Run] on [Start] menu.
2.
Type "cmd.exe" in the [Open:] box to start command prompt.
3.
Execute following command line.
bcdedit /set pae forceenable
4.
Reboot the system.
The setting mentioned above enables after reboot.
5.
Execute following command line on command prompt.
bcdedit
Confirm "pae ForceEnable" exists in "Windows boot loader".
The setting for PAE option is now completed.
Refer following site about Bcdedit.exe.
"Boot Configuration Data Editor Frequently Asked Questions"
http://technet.microsoft.com/en-us/library/cc721886(WS.10).aspx
Setting for Solving Problems
Setup your computer in advance so that it can recover from any trouble precisely and as soon as
possible when it should occur.
For more information, see Page 5-88.
Installing the Operating System with Express Setup 5-59
Advertisement
Table of Contents
Troubleshooting
