NEC Express5800/R120b-1 User Manual page 529

WOL
Refer to the following procedure for WOL (Wake On LAN) setting.
When PROSet is not installed
1.
Start Device Manager.
2.
Point to [Network adapters] and double click following adapter.
Open the adapter [Properties].
[Intel(R) 82576 Gigabit Dual Port Server Network Connection]
[Intel(R) 82576 Gigabit Dual Port Server Network Connection #2]
3.
Click [Power Management] tab and change setting in [Wake On LAN] according to the
following list.
Setting item
"Allow the computer to turn off this device to save power"
"Allow this device to bring the computer out of standby"
IMPORTANT:
Set "Allow this device to bring..." "ON", WOL by Directed
Packet(*1) or Magic Packet will available on Standby and Hibernate
state.
WOL by Directed Packet is not available on Shutdown state.
*1 Packet with the Ethernet address of the adapter in Ethernet header or
Packet with an IP address assigned to the adapter in IP header.
4.
Click [Advanced] tab and point to [Enable PME].
5.
Set in [Value] as follows.
– Using WOL : ON
– Not using WOL: OFF
6.
Click [OK].
7.
Restart the system.
Installing Windows Server 2003 x64 Editions F-21
Using Not using
WOL WOL
ON ON
ON or OFF OFF