Table of Contents
Advertisement
Configuring Motherboard Jumpers
With the pre-installed SETUP utility, you can set a password to protect the data stored in the server
against access from unauthorized users. When you forget the password, however, you might have to
remove it as described below. The procedure for clearing the CMOS data on the server is also
described below.
IMPORTANT:
Clearing the CMOS data restores the factory settings.
After clearing CMOS, you must run the BIOS SETUP utility and execute the
following menus to reconfigure your motherboard.
– Load Setup Defaults in the Save & Exit menu
– Memory Retest of Memory Configuration in the Advanced menu
Do not change any other switch settings. Any change may cause the server to fail
or malfunction.
To remove the password or clear the CMOS data, use the corresponding jumper switch on the
motherboard of the server. The following figure illustrates the jumper switch location.
Front
Pin for protecting/
removing the password
3 2 1
3 2 1
Protect
Remove
Motherboard
Configuring Your Server 4-61
Pin for protecting/
clearing the CMOS contents
3 2 1
3 2 1
Protect
Clear
Rear
Advertisement
Table of Contents
Troubleshooting
