Table of Contents
Advertisement
9-14 Upgrading Your Server
7.
When the handle begins to close by itself, slowly close the handle.
The drive carrier is locked when a "click" is heard.
IMPORTANT:
Be careful not to get your finger caught between the handle and tray.
Push the drive further to check if it is firmly secured.
NOTE:
inserted the hard disk drive.
8.
Power on the server, and run the SETUP utility.
Select the [Boot] menu (described on page 4-33) to set the boot priority. When you install
an additional hard disk drive, the boot priority stored in BIOS is cleared.
9.
Install the front bezel you removed in step 2.
There are tabs on the left side of the front bezel. Engage the tabs with the server frame,
install the front bezel, and lock it with the security key.
Confirm that the handle is hooked to the frame when having
Advertisement
Table of Contents
Troubleshooting
