Errors; Printing Of Filled Patterns - Epson Stylus Photo 895 Service Manual

EPSON Stylus PHOTO 895/785EPX

1.9 Errors

Ink Out
When the printer runs out most of the ink of any color, it indicates ink-low and
keeps printing. When the printer runs out the whole ink of any color, it stops
printing and indicates ink-out error. User is then requested to install a new ink-
cartridge in this state. An ink-cartridge that has been taken out once should never
be used again. Re-installation of the cartridge not filled fully upsets the ink level
detection and may eventually cause a serious problem in the print head.
Paper Out
When the printer fails to load a sheet, it goes into a paper out error.
Paper Jam
When the printer fails to eject a sheet, it goes into a paper jam error.
No Ink-Cartridge
When the printer detects that ink-cartridge comes off, or failed to read or write
CSIC data, it goes into this error mode.
Maintenance Request
When the total amount of ink wasted through cleanings and flushing reaches to the
limit, printer indicates this error and stops. In such a case, the absorber in the
printer enclosure needs to be replaced with new one by service personnel.
Fatal Errors
Carriage control error.
PRODUCT DESCRIPTION

1.10 Printing of filled patterns

Filled patterns can be printed by the following methods.
Printing by Remote Command
Use the NC command from the remote commands.
Status Printing
Turn the power on while pressing the Paper Feed / Eject button.
Print by the D4 Control Command
Send the NC command by the C4 command channel.
Errors
Revision A
21