Monochrome Panel Board Removal - Epson Stylus Photo 895 Service Manual

EPSON Stylus PHOTO 895/785EPX

4.2.2.2 Monochrome panel board removal

1. Remove the housing. (Refer to Section 4.2.1 "Housing Removal")
2. Remove four screws (C.B.P. 3x8, F/ZN) and detach the monochrome panel board.
3. Remove two screws (C.B.S. 3x6, F/ZN) located on the rear of the monochrome
panel board and detach the panel shield plate.
Figure 4-9. Monochrome panel board
4. Remove the FFC from the monochrome panel board connector.
Pay attention since the buttons of monochrome panel will be not
fixed anymore if the monochrome panel board is detached.
Disassembly and Assembly
C.B.P 3x8 F/ZN
Tightening torque for screw
• C.B.S 3x6, F/ZN screw for monochrome panel board: 6 +/- 1 kgf.cm
• C.B.P 3x8, F/ZN screw for panel shield plate: 6 +/- 1 kgf.cm
Disassembly
Revision A
77