Epson Stylus Photo 895 Service Manual page 62

EPSON Stylus PHOTO 895/785EPX
Table 3-11. Fatal Error indication
Step
Detail phenomenon
No.
1. Check if the Top
When the printer is
housing is secured with
turned on, it sounds
the fixing screw at the
strange noise and the
front side.
CR unit is stopped
around the CR lock
lever.
2. Check if the Change
lever is placed to the
4
printer front side.
3. Check if the ASF motor
is operated. Check the
CN11 connector and
the coil resistance for
ASF motor.
Troubleshooting
Check point Remedy
1. Secure the Housing fixing
screw at the printer front
side.
Top housing
2. Turn back the Change
lever to the printer back
side with the tweezer or
small screw driver.
Change lever
3. Connect the ASF motor
cable to CN11 on the
Main board.
Replace the ASF motor
with new one.
Troubleshooting with LED Error Indications
Table 3-11. Fatal Error indication
Step
Detail phenomenon Check point
No.
4. If the CR lock lever is
Ditto
not released even if the
ASF motor rotate in the
power on sequence,
check if one of the
gears has any damage
in the ASF motor
4
torque transportation
path.
Refer to Figure 2-15.
"ASF Motor Drive
Transmission Path to
the Pump Unit" to the
Pump unit.
Revision A
Remedy
4. Change the damaged gear
with new one.
5. If the problem is not
solved, replace the Main
board with new one.
62