Epson Stylus Photo 895 Service Manual page 90

EPSON Stylus PHOTO 895/785EPX
Do not damage the tooth of the Spur gear 35.2 and the Spur gear
23.2 when assembling the LD roller shaft holder unit
Figure 4-30. Spur Gear 23.2 and Spur Gear 35.2
Disassembly and Assembly
Spur gear 35.2
Spur gear 23.2
Disassembly
Before assembling the LD roller shaft, make sure that the round
hole of the Clutch is set on the protrusion on the LD roller shaft
as shown in the following figure.
Round hole on the Clutch
Protrusion on the LD roller shaft
Figure 4-31. Assembling the Clutch
Assemble the LD roller shaft holder unit to the printer
mechanism in the following procedure.
1. Set the tip of the Change lever to the printer front side.
Change lever
Figure 4-32. LD Roller shaft holder assembling procedure (1)
Revision A
90