Epson Stylus Photo 895 Service Manual page 69

EPSON Stylus PHOTO 895/785EPX
Avant de commencer, assurez vous que l'imprimante soit eteinte
et que le cordon d'alimentation soit debranche.
Lorsque vous changez la pile au lithium, assurez vous que la
nouvelle respecte bien les caracteristiques requises.
Lorque que vous installez la pile au lithium, faites attention a
l'inserer dans le bon sens en respectant la polarite.
Veillez a jeter les piles usagees selon le reglement local.
Ne rechargez pas les piles au lithium.
Risque d'explosion si la pile est remplacée incorrectment. Ne
remplacer que par une pile du même type ou d'un type
équivalent recommandé par le fabricant. Eliminer les piles
déchargées selon les lois et les règles de sécurité en vigueur.
When working on the FUSER ASSY or nearby parts, be sure to
wait until the temperature of the parts cool down to a safe level.
Wait at least 40 minutes before you start working on the printer.
Disassembly and Assembly
Never remove the ink cartridge from the carriage unless this
manual specifies to do so.
When transporting the printer after installing the ink cartridge,
be sure to pack the printer for transportation without removing
the ink cartridge.
Use only recommended tools for disassembling, assembling or
adjusting the printer.
Observe the specified torque when tightening screws.
Apply lubricants and adhesives as specified. (See Chapter 6 for
details.)
Make the specified adjustments when you disassemble the
printer.
(See Chapter 5 for details.)
When assembling, if an ink cartridge is removed and needs to be
installed again, be sure to install a new ink cartridge because of
the following reasons;
1.Once the ink cartridge mounted on the printer is removed, air
comes in and creates bubbles in the cartridge. These bubbles clog
ink path and cause printing malfunction.
2.If an ink cartridge in use is removed and is reinstalled, ink quantity
will not be detected correctly since the counter to check ink
consumption is cleared.
Because of the reasons above, make sure to return the printer to
the user with a new ink cartridge installed.
Make sure the tip of the waste ink tube is located at correct
position when reassembling the waste ink tube. Otherwise it will
cause ink leakage.
Overview
Revision A
69