Epson Stylus Photo 895 Service Manual page 74

EPSON Stylus PHOTO 895/785EPX
Figure 4-5. Removing the right side housing
Tightening Torque for screw
• C.B.S-TITE 3x6 F/ZN screw for housing front side: 6 +/- 1kgf.cm
• C.B.S 3x6 F/ZN screw for housing back side
Ensure that C.B.S-TITE 3 x 6 F/ZN screws are used for the two
screws on the front side of the printer. The tips of these screws
are rounded for user's safety.
To detach the housing, pay attention since the monochrome
panel FFC is installed.
Disassembly and Assembly
4. Remove the FFC of housing monochrome panel board.
: 6+/- 1kgf.cm
Disassembly
FFC connector
Figure 4-6. Housing FFC removal
Revision A
74