Epson Stylus Photo 895 Service Manual page 94

EPSON Stylus PHOTO 895/785EPX
4. Remove four screws (C.B.S 3x6 F/ZN) securing the Ink system frame and the Cap
assembly to the frame.
C.B.S 3x6 F/ZN
Figure 4-41. Removing four screws securing the Ink system
Tightening torque for screw
• C.B.S (P4) 3x6 F/ZN screw for pump unit cover: 9 +/- 1 kgf.cm
• C.B.S 3x6, F/ZN screw for ink system frame and cap assembly: 9 +/- 1 kgf.cm
5. Remove the Ink system unit (Cap and Pump unit) carefully along with the Ink
system frame.
When the Ink system unit is removed, be careful that the gears do
not come off from each shaft on the Ink system frame.
Disassembly and Assembly
6. Release one hook for Cap assembly on the Ink system frame and take the Cap
assembly out from the Ink system frame.
7. Disconnect the waste drain ink tube carefully from the bottom of the Cap assembly
Disassembly
Revision A
94