Epson Stylus Photo 895 Service Manual page 60

EPSON Stylus PHOTO 895/785EPX
Table 3-7. Paper jam error indication
Step
Detail phenomenon
No.
1. Check if the CN4
When the paper is
connector cable for PE
loaded from the ASF
sensor cable is
and ejected without any
disconnected on the
printing. After eject the
Main board or sensor.
paper, paper eject
5 sequence is continued. 2. Check if the PE sensor
operates correctly by
using the tester. Refer
to Table 3-2 "Sensor
Check Point".
Table 3-8. No Ink Cartridge or Ink Out error indication
Step
Detail phenomenon
No.
1. Check to ascertain that
A [No Ink Cartridge] or
an ink cartridge has
[Ink Out Error] message
been set in place.
is displayed when the
power to the printer is 2. Check the remaining
switched on. ink with the printer
driver or STM3.
3. Check to ascertain that
the head FFC is been
attached correctly to the
1
head.
4. Check if the head FFC
has any damaged.
5. Check if the I/C works
correctly.
Troubleshooting
Check point Remedy
1. Connect the CN4
connector cable to the
CN4 on the Main board.
2. Replace the PE sensor
with new one.
3. If the problem is not
solved, replace the Main
board with new one.
Check point Remedy
1. Set the ink cartridge in
place.
2. Remove and then reset the
ink cartridge in place.
3. Connect the Head FFC.
4. Replace the Head FFC.
5. Replace the ink cartridge
(faulty CSIC.)
6. If the problem is not
solved, replace the Main
board with new one.
Troubleshooting with LED Error Indications
Table 3-9. Multiple papers are always loaded
Step
Detail phenomenon Check point
No.
Any error indication is Check if the Paper return
not displayed on the plate is operating correctly
monitor. But, multiple in the ASF when the paper
papers are always is loaded.
loaded from ASF.
1
Table 3-10. Paper is always loaded without any print job
Step
Detail phenomenon Check point
No.
1. Check if the tip of the
Paper is always loaded
Change lever has any
from ASF without any
damage.
print job.
ASF hopper continue to 2. Check if the
flapping when the Compression spring
printer is turned on. 2.94 comes off from the
Change lever.
1
comp. spring 2.94
Revision A
Remedy
• Assemble the torsion
spring 25.7 in the ASF
frame.
Torsion spring 25.7
Remedy
1. Replace the Change lever
with new one.
2. Set the Compression
spring 2.94 in the Change
lever.
Change lever
60