Epson Stylus Photo 895 Service Manual page 56

EPSON Stylus PHOTO 895/785EPX
Following table describes the possible causes when the error is indicated with
LED and LCD, or troubles in other conditions.
Table 3-5. Error Condition and possible cause
Symptom
• The friction of the LD roller is lowered due
to the paper dust.
• The clutch mechanism is broken.
Paper out error indication
• Tension spring 0.143 come off in the clutch
(Paper is not loaded
mechanism.
correctly)
• Compression spring 4.8 comes off.
• Tip of Change lever has any damage.
• ASF motor is broken.
• Star wheel assembly is not assembled on the
Paper eject frame.
• The Spur gear 25.6 is not assembled
correctly.
Paper jam error indication
• The paper guide front is not assembled
correctly or has any damage.
• The PE detection lever dose not move
smoothly.
• Ink cartridge installation faulty.
No ink cartridge error / No • Head FFC connection faulty.
ink error
• Ink cartridge CSIC faulty.
• The paper return plate dose not work
correctly.
Multiple papers are always
loaded
• The Change lever is broken in the Clutch
mechanism.
Paper is always loaded
without any print job
Troubleshooting
Possible Cause Check table
Table 3-6
"Paper out error
indication"
Table 3-7
"Paper jam
error
indication"
Table 3-8 "No
Ink Cartridge or
Ink Out error
indication"
Table 3-9
"Multiple
papers are
always loaded"
Table 3-10
"Paper is
always loaded
without any
print job"
Troubleshooting with LED Error Indications
Table 3-5. Error Condition and possible cause
Symptom
• Count up of the protection counter
Maintenance request error
• HP sensor lever or PE sensor lever dose not
move smoothly.
• HP/PE sensor is defective.
• CR motor is defective.
Fatal error indication
• ASF motor is defective.
• Main board is defective.
• Printer Housing dose not secured with screw
on -the printer mechanism.
• PF motor is defective.
• PF motor is disengaged from the PF roller
Any error indication is not
gear.
displayed. But the paper is
not loaded completely.
• Paper eject roller gear is disengaged from the
pump's gears.
Any error indication is not
• The Paper eject frame is not assembled in the
displayed. But, the paper is
Paper eject frame.
not ejected completely.
Paper jam dose not occur.
• Pump unit dose not absorb the ink from the
printhead.
• Cap unit dose not stick on the surface of the
Dot missing occur and it is
printhead completely.
not recovered with CL
• The printhead is broken.
• The head FFC has any damage.
• The main board is defective.
Revision A
Possible Cause Check table
Table 1-6
"Special
Setting Mode"
Table 3-11
"Fatal Error
indication"
Table 3-12
"Paper is not
loaded
completely
without any error
indication"
Table 3-13
"Paper is not
ejected
completely
without any
error
indication"
Table 3-14
"Dot missing
occur and it is
not recovered
with CL"
56