Pf Motor Removal - Epson Stylus Photo 895 Service Manual

EPSON Stylus PHOTO 895/785EPX
When you assemble the Front frame to the Printer mechanism,
set the CR unit to the left side and assemble the Front frame
from the right side. Be careful not damage the CR lock lever.
Fasten the Front frame with C.B.S Screw 3x6 F/ZN in the order
of 1, 2, 3.
2
Figure 4-50. Installing the Front Frame
Tightening torque for screw
• C.B.S 3x6 F/ZN screw for Front frame
Disassembly and Assembly
1
3
: 9+/-1 kgf.cm

4.2.14 PF motor removal

1. Remove the Housing from the printer. (Refer to Section 4.2.1 "Housing
Removal")
2. Remove the Waste drain ink pad unit from the printer. (Refer to Section 4.2.6
"Waste drain ink pad unit removal")
3. Remove the printer mechanism from the printer (Refer to Section 4.2.7 "Printer
mechanism removal").
4. Remove the Front frame and Paper eject roller. (Refer to Section 4.2.13 "Paper
Eject Roller removal")
5. Remove the Plain washer and then remove the Combination gear 11.6, 36.8
carefully. Refer to Figure 4-51. "Removing the Plain washer and Combination
gear 11.6, 36.8".
Figure 4-51. Removing the Plain washer and Combination gear 11.6, 36.8
Disassembly
Revision A
Combination Gear 11.6, 36.8
Plain Washer
100