Epson Stylus Photo 895 Service Manual page 110

EPSON Stylus PHOTO 895/785EPX
7. Remove the Pad holder (Paper return plate) from the ASF frame
Pad Holder
Figure 4-70. Removing the Pad holder (Paper return plate)
Make sure that the each tip of the Torsion spring 25.7 is set in the
slot of the Pad holder and ASF frame. Refer to Figure 4-69.
"Removing the Torsion spring 25.7".
Make sure that the Pad holder moves smoothly after assembling
it to the ASF frame.
Disassembly and Assembly
ASF Frame
When you replace the ASF frame or Hopper with the new one,
make sure to lubricate the specific amount of G26 into the groove
on ASF frame. Refer to Figure 6-6. "Lubrication point 6" and
Figure 6-4. "Lubrication point 4" in the Chapter 6.
Fasten the ASF unit C.B.S-TITE (P4) 3x8 F/ZN screw (left screw
in the following figure), C.B.S-TITE (P4) 3x6 F/ZN screw (right
screw in the following figure) in the order of following figure.
Figure 4-71. ASF fixing screws fastening order
Tightening torque for screw
• C.B.S-TITE (P4) 3x6 F/ZN screw for ASF
(right screw in above figure)
• C.B.S-TITE(P4) 3x8 F/ZN screw for ASF
(left screw in above figure)
Disassembly
2
Revision A
1
: 9+/-1 kgf.cm
: 9+/-1kgf.cm
110