Epson Stylus Photo 895 Service Manual page 81

EPSON Stylus PHOTO 895/785EPX
Figure 4-15. Placing the Printhead's FFC
Disassembly and Assembly
Figure 4-16. Printhead installing the position pin & the grounding plate
Tightening Torque for screw
• C.B.P-TITE 3x8 F/ZN screw for printhead: 6 +/- 1 kgf.cm
• B-TITE SEMSW2 2.5x5, F/ZB screw for printhead: 2 +/- 0.5 kgf.cm
When the Printhead is replaced with a new one, following
adjustments must be performed in the order below:
1. Initial ink charge
2. Printhead ID input
3. Bi-d adjustment
When the Printhead is removed and reinstalled, only the following
adjustment is required.
1. Head cleaning
2. Bi-d adjustment
Disassembly
Head installing position pins
Head grounding plate
Revision A
81