Forms Tear-Off Feature; Paper Park Feature - OKIDATA ML320 User Manual

Forms Tear-Off Feature

Important! Never engage Forms Tear-Off when printing on
labels!
The Forms Tear-Off feature automatically moves
continuous-form paper up to the tear position after the
interval you select, then moves it back down again for
printing when the printer receives more data.
This feature is normally turned off. To activate it:
SEL
LF
SEL
Micro Feed
MENU SHIFT
Down
EXIT GROUP
POWER ALARM
1. Press ( ) +
SHIFT SEL
2. Press ( ) until one of the following lines
GROUP
appears, depending on which paper feed you are using:
REAR FEED Form Tear-Off
BOTTOM FEED Form Tear-OFF
E-30 Section 3
FF/LOAD TEAR PARK QUIET
Micro Feed
TOF
Up
ITEM SET PRINT
MENU
( ).
OFF
OFF
3. Press ( ) until the time interval you wish to select
SET
appears in the third column.
4. Press ( ) +
SHIFT SEL
the setting.
Note: Some programs pause occasionally while sending
data. If the pause is too long, the paper will advance
to the tear-off position until more data is received.
This extra paper movement can cause uneven print
registration in graphics. If you have this problem,
use the menu to turn off this feature.

Paper Park Feature

SEL
LF
SEL
Micro Feed
SHIFT
MENU
Down
EXIT GROUP
POWER ALARM
To retract rear-feed paper form the paper path, press
( ).
( ) to exit Menu Mode and save
FF/LOAD TEAR PARK QUIET
Micro Feed
TOF
Up
PRINT
ITEM SET
MENU
PARK