Connecting To A Power Supply - Christie LX750 User Manual

6. Connecting to a power supply

In accordance with the warnings shown below, connect
the AC inlet of the projector to the proper power outlet.
The following walks you through the connection.
1. Make sure that the power switch of the projector
is set to the off-position (marked with "O").
2. Insert the socket end of the power cord into the
AC IN (AC inlet) of the projector.
3. Plug the other end of the power cord into the
power outlet.
WARNING
● Do not connect the projector to a power supply when the lens unit is not attached.
● Use this projector from only the specified power supply in accordance with the label
indication on the projector.
● Use a power outlet that is close to the projector and easily accessible.
● Do not overload the outlet, since overloading can result in a fire or an electric shock.
● Use only the power cord that came with this product and is suitable for your power
supply. If the suitable power cord did not come with this product, consult your dealer.
● Do not use a damaged power cord. If the power cord you need is damaged, ask your
dealer for a new power cord of the same type.
● Do not handle the power cord with wet hands.
● Do not repair or modify the power cord.
● Be careful not to damage the power cord. Route the power cord so that it is not likely
to be walked on or pinched by items placed upon or against them.
● Connect firmly the power cord not to result in loose connection. Do not use a loose or
unsound power outlet.
LX750/LW650/LS+700 User Manual-Concise
Socket end of
the power cord
12
AC IN
Power switch
020-000158-01 Rev. 1 (03-2009)