Connecting With Your Devices - Christie LX750 User Manual

5. Connecting with your devices

Before connecting the projector to your devices, check the manual of the device in order
to make sure that the device is suitable to connect with this projector and to check what is
required for the connection.
Consult your dealer when the required accessory did not come with the product or the
accessory is damaged. It may be regulated under some standard.
After making sure that the projector and the devices are turned off, perform the
connection, according to the following instructions. Refer to the figures in subsequent
pages.
NOTE
* For this product, the optional cable cover is ready to be purchased. To place an order for
it, please tell your dealer the type name of it.
WARNING
● Use only the accessories specified or recommended by manufacturer. Modify neither a
projector nor accessories.
● Read and keep the user's manual of the accessories used.
● Do not connect or disconnect the projector with devices while they are connected to a
power supply except for the cases directed by the manuals of devices.
CAUTION
● Some connecting cable may have to have a specific length, or a ferrite core at the
end to connect to the projector, under the regulation of electro-magnetic interference.
When a ferrite core is attached to the specified cable only at one end, connect to the
projector the end that the ferrite core is attached at.
● Be careful not to set a connector into a wrong port or with a wrong way.
● Be careful not to damage the cables. Route the cables not to be stepped on and pinched
out.
NOTICE
● Do not turn your device on prior to the projector, except for the cases directed by the
manuals of devices.
LX750/LW650/LS+700 User Manual-Concise
9
020-000158-01 Rev. 1 (03-2009)