Table of Contents
Advertisement
9.4 Adjusting the projection position
Using the elevator feet
Lengthening or shortening the length of the elevator feet
shifts the projection position and the projection angle.
Turn the elevator feet each to adjust their length.
WARNING
● Do not lengthen the elevator feet exceeding 30 mm.
The foot lengthened exceeding the limit may come off
and drop the projector down, and result in an injury or
damaging the projector.
CAUTION
● Do not place the projector with an inclination exceeding
5 degrees. The projector leaned exceeding the limit
could cause malfunction and shorten the life of the
projector.
Adjusting the lens position
Shifting the lens position shifts the projection position.
After pressing the LENS SHIFT button (on the control panel or the remote control), use
the cursor buttons to shift the lens position.
NOTE
* While the lens is moving, the LENS SHIFT indicator (on the control panel) lights up or
blinks green. The projector may ignore operation by buttons while moving the lens.
* Generally, better image quality can be got when the lens is set to the center.
CAUTION
● Do not put your fingers or any other things around the lens. The moving lens could
catch them in the space around the lens and result in an injury.
9.5 Selecting an aspect ratio
Use the ASPECT button (on the remote control). Each time you press the button, it
changes the aspect ratio of the image in turn.
9.6 Correcting the keystone distortion
Pressing the KEYSTONE button (on the remote control) displays the KEYSTONE
dialog. Use the cursor buttons according to the dialog, checking the image.
LX750/LW650/LS+700 User Manual-Concise
17
max. 30 mm
020-000158-01 Rev. 1 (03-2009)
Advertisement
Table of Contents
