Table of Contents
Advertisement
WARNING
HIGH VOLTAGE
● The projector uses a high-pressure mercury glass lamp. The lamp can break with a
loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time.
Note that each lamp has a different lifetime, and some may burst or burn out soon
after you start using them. In addition, when the bulb bursts, it is possible for shards of
glass to fly into the lamp housing, and for gas containing mercury to escape from the
projector's vent holes.
● About disposal of a lamp: This product contains a mercury lamp; do not put it in a
trash. Dispose of it in accordance with environmental laws.
- For lamp recycling, go to www.lamprecycle.org (in the US).
- For product disposal, contact your local government agency or www.eiae.org (in the
US) or www.epsc.ca (in Canada).
For more information, call your dealer.
● If the lamp should break (it will make a loud bang when it does),
Disconnect the
● If the lamp should break (it will make a loud bang when it does),
plug from the
power outlet
● Before replacing the lamp, turn the projector off and unplug the
● Never unscrew except the appointed (marked by an arrow) screws.
● Do not open the lamp cover while the projector is suspended from
● Do not use the projector with the lamp cover removed. At the lamp
● Use only the lamp of the specified type.
● If the lamp breaks soon after the first time it is used, it is possible
● Handle with care: jolting or scratching could cause the lamp bulb to
● Using the lamp for long periods of time, could cause it to darken, not
LX750/LW650/LS+700 User Manual-Concise
HIGH TEMPERATURE
unplug the power cord from the outlet, and make sure to request
a replacement lamp from your local dealer. Note that shards of
glass could damage the projector's internals, or cause injury during
handling, so please do not try to clean the projector or replace the
lamp yourself.
ventilate the room well, and make sure not to breathe the gas that
comes out of the projector vents, or get it in your eyes or mouth.
power cord, then wait at least 45 minutes for the lamp to cool
sufficiently. Handling the lamp while hot can cause burns, as well as
damaging the lamp.
a ceiling. This is dangerous, since if the lamp's bulb has broken, the
shards will fall out when the cover is opened. In addition, working in
high places is dangerous, so ask your local dealer to have the lamp
replaced even if the bulb is not broken.
replacing, make sure that the screws are screwed in firmly. Loose
screws could result in damage or injury.
that there are electrical problems elsewhere besides the lamp. If this
happens, contact your local dealer or a service representative.
burst during use.
to light up or to burst. When the pictures appear dark, or when the
color tone is poor, please replace the lamp as soon as possible. Do not
use old (used) lamps; this is a cause of breakage.
20
HIGH PRESSURE
020-000158-01 Rev. 1 (03-2009)
Advertisement
Table of Contents
