Table of Contents
Advertisement
8. Turning the projector on/off
8.1 Turning on
1. Make sure that the power cord is firmly and
correctly connected to the projector and the
outlet.
2. Press down the side marked "I" on the power
switch.
The POWER indicator will light up in steady
orange. Wait for the buttons to become ready. It
may take several seconds.
3. Press the STANDBY/ON button (on the
projector or the remote control).
The projection lamp will light up and the
POWER indicator will begin blinking in
green. When the power is completely on, the
indicator will stop blinking and light in steady
green.
8.2 Turning off
1. Press the STANDBY/ON button on the projector or the remote control.
The message "Power off?" will appear on the screen for about 5 seconds.
2. Press the STANDBY/ON button again while the message is shown.
The projector lamp will go off, and the POWER indicator will begin blinking in
orange.
Then the POWER indicator will stop blinking and light in steady orange when lamp
cooling is complete.
3. After making sure that the POWER indicator lights in steady orange, and press down
the side marked "O" on the power switch.
The POWER indicator will go off.
NOTE
* When the item DIRECT ON of the OPTION menu is set to the ON, and that the
projector was turned off by only the power switch without using the STANDBY/ON
button, switching the power switch turns the projector automatically.
WARNING
● Do not look directly into the lens or the openings on the projector while the lamp is
on.
● Do not approach the lamp cover and the exhaust vents for a while after the lamp goes
out, since they may be hot and could cause burns.
NOTICE
● Do not turn your device on prior to the projector, except for the cases directed by the
manuals of devices. Turn your device off prior to the projector, except for the cases
directed by the manuals of devices.
LX750/LW650/LS+700 User Manual-Concise
Power switch
15
POWER
indicator
STANDBY/ON
button
STANDBY/ON
button
STANDBY/ON
020-000158-01 Rev. 1 (03-2009)
Advertisement
Table of Contents
