Turning On; Turning Off; Changing Light And Contrast - Standard Horizon CP150 Owner's Manual

Figure 4.1.3 - Power On
Check also for the correct connection of the GPS antenna.

4.1.3.1 Turning On

Press and hold 'PWR' for 1 second. The chartplotter emits one rapid beep sound and
the Start-Up pages are opened:
Figure 4.1.3.1 - Start-Up pages
NOTE
The software version is subject to change without notice.
After a few seconds, the first of the two Caution Notice pages is displayed, reminding
you that the chartplotter is only an aid to navigation, and should be used with
appropriate prudence. The electronic charts are not intended to substitute official
charts. Then the cartographic screen is displayed.

4.1.3.2 Turning Off

Press 'PWR' and hold for 3 seconds: a countdown timer appears on the screen, if you
release the key before the countdown timer reaches zero, the chartplotter will remain
On.

4.1.4 Changing Light and Contrast

Press and immediately release 'PWR' (do not press and hold the key, or the "power-
off" message will be displayed!): use the ShuttlePoint knob to increase/decrease the
light (move it left/right) and the contrast (move it up/down). Press 'ENTER' to confirm
the setting.
GPS Chart 150 Page 27