Starting The Scsiselect Utility; Using Scsiselect Menus; Exiting Scsiselect - Adaptec AAA-130SA SERIES Installation And Hardware Manual

Starting the SCSI Select Utility
To start SCSISelect, press the F6 key when the following prompt
appears when you turn on or reboot your computer:
Press <F6> for SCSISelect (TM) Utility!
The menu that appears displays the options Configure/View Host
Adapter Settings and SCSI Disk Utilities, as shown in Figure A-1.
Adaptec AAA-13x/ARO-113x
Would you like to configure the PCI device, or run the
SCSI disk utilities? Select the option and press <Enter>.
Press <F5> to switch between color and monochrome modes.
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit ( * =default)
Using SCSI Select Menus
To select a SCSISelect menu option, move the cursor to the option
with the and
option displays another menu. You can return to the previous menu
at any time by pressing Esc.
To restore the original SCSISelect default values, press F6 from the
main SCSISelect screen. To toggle the display between color and
monochrome modes, press F5 from the main SCSISelect screen (this
feature may not work on all monitors).
Exiting SCSI Select
To exit SCSISelect, press Esc until a message prompts you to exit (if
you changed any host adapter settings, you are prompted to save
the changes before you exit). Select Yes to exit, then press any key to
reboot the computer. Any changes you made in SCSISelect take effect
after the computer boots.
Configuring the AAA-13xSA RAID Card with SCSISelect
AAA-13x/ARO-113x at Bus:Channel 00:C
Options
Configure/View Host Adapter Settings
SCSI Disk Utilities
Figure A-1. SCSI Select Menu
keys, then press Enter. In some cases, selecting an
SCSISelect(TM) Utility v2.00
A-3