Installing The Aaa-13Xsa Raid Card - Adaptec AAA-130SA SERIES Installation And Hardware Manual

AAA-130SA Series Installation and Hardware Guide

Installing the AAA-13xSA RAID Card

Follow these steps to install the AAA-13xSA RAID card:
Note:
If you are installing the AAA-13xSA RAID card in an
existing system, back up all data before continuing with
installation.
1
Turn power to the computer and disconnect the power
OFF
cord.
2
Remove the cover from the computer.
3
Locate an unused, unobstructed, PCI expansion slot and
remove the expansion slot cover. (The expansion slot must be
Rev. 2.1 or higher compliant and support bus mastering.) Save
the slot cover screw for use in Step 4.
4
Insert the AAA-13xSA RAID card in the PCI expansion slot;
press down firmly until it clicks into place, then replace the slot
cover screw. (Figure 2-4 shows the installation of an
AAA-131SA card.)
Figure 2-4. Installing an AAA-131SA in PCI Expansion Slot
2-4
AAA-131SA Card Installed in
PCI Expansion Slot