Adaptec AAA-130SA SERIES Installation And Hardware Manual page 43

2
Windows NT Boot diskette installation: When prompted, insert
diskette #2 in your floppy drive. After a few moments you will
see a blue screen. To setup Windows NT now, press Enter and
continue with Step 3 below.
Windows NT Boot CD-ROM installation: When the following
message appears onscreen, press the F6 key and skip to Step 4
below.
Setup is inspecting your computer system's hardware...
3
Press S to skip autodetection of your SCSI host adapter.
4
Press S again to specify an additional peripheral.
5
Press Enter to select Others; insert the Adaptec Array1000SA
Family Manager Set driver diskette in your floppy disk drive
and press Enter.
6
The screen displays the adapter drivers supported on the
diskette. Select the Adaptec Array1000SA Family Adapter
driver and press Enter.
7
If you want to add drivers (other than for the AAA-13xSA
RAID card), press S and repeat Step 5 for each additional
adapter and inserting the appropriate disk provided by the
hardware manufacturer.
8
Press Enter to continue with the Windows NT operating
system setup. Follow the instructions onscreen and in the
Windows NT documentation to complete the installation.
Installing Software on a Windows NT Server
4-3