Starting The Scsiselect Utility; Using Scsiselect Menus; Exiting Scsiselect - Adaptec AAA-130U2 Installation And Hardware Manual

Starting the SCSI Select Utility
To start SCSISelect, press the F6 key when the following prompt
appears when you turn on or reboot your system:
Press <F6> for SCSISelect (TM) Utility!
The menu that appears displays the options Configure/View Host
Adapter Settings and SCSI Disk Utilities, as shown in Figure A-1.
Adaptec Array1000 Family
Adaptec Array1000 Family at Bus:Channel 00:A
Would you like to configure the PCI device, or run the
SCSI disk utilities? Select the option and press <Enter>.
Press <F5> to switch between color and monochrome modes.
Configure/View Host Adapter Settings
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit ( * =default)
Figure A-1. SCSI Select Menu
Using SCSI Select Menus
To select a SCSISelect menu option, move the cursor to the option
with the and keys, then press Enter. In some cases, selecting an
option displays another menu. You can return to the previous menu
at any time by pressing Esc.
To restore the original SCSISelect default values, press F6 from the
Configure/View Host Adapter Settings screen. To toggle the display
between color and monochrome modes, press F5 from the main
SCSISelect screen (this feature does not work on some monitors).
Exiting SCSI Select
To exit SCSISelect, press Esc until a message prompts you to exit (if
you changed any host adapter settings, you are prompted to save
the changes before you exit). Select Yes to exit, then press any key to
reboot the system. Any changes you made in SCSISelect take effect
after the system boots.
Using SCSISelect and Disk Utilities
SCSISelect(TM)
Options
SCSI Disk Utilities
Utility
A-3