Installing Adaptec Ci/O Management Software For Windows Nt Server - Adaptec AAA-130SA SERIES Installation And Hardware Manual

AAA-130SA Series Installation and Hardware Guide
Installing Adaptec CI/O Management Software
for Windows NT Server
Note:
The Adaptec CI/O Management Software installation
process automatically installs both CI/O server and client
components on your Windows NT Server. Before you start
the Adaptec CI/O Management Software, be sure that com-
munication with the server via the network is already estab-
lished. (See the documentation provided with your TCP/IP
software for instructions on establishing communications,
and also Hints for Establishing Communications With Your
Server on page 6-3.)
Follow these steps to install the Adaptec CI/O Management Soft-
ware for Windows NT:
1
Start Windows NT.
2
Insert the Adaptec CI/O Management Software CD-ROM in
your CD-ROM drive.
3
Select Start and then Run, type the following and press Enter:
x :\win_nt\disk1\setup.exe
where x is the CD-ROM drive letter.
4
Follow the directions that appear on the screen.
5
When installation is complete, reboot the system. The follow-
ing NT Services start automatically in the background:
CIO Array Management Service
CIOArrayManager RPC Command
CIOArrayManager RPC EventP
CIOArrayManager RPC Event
NobleNet Portmapper
Note:
matically at boot time. After installation you can start
or stop these services through the Services icon in the
Windows NT Control Panel.
4-6
These NT Services are configured to start auto-