Main Dpc Menu - Comtech EF Data Vipersat CDM-570 User Manual

Parameter
Calculate Max
Power
Max Power

Main DPC Menu

The main menu provides the basic configurable parameters: Enable DPC,
Target Eb/No, Speed Up Eb/No Range, and Target DPC Address. Each of these
main menu parameters are configurable from either the CLI or the Parameter
Editor, as shown in figure C-3 and figure C-4.
For simplicity, only CDM-IP menus are shown.
When using the CLI, select Dynamic Power Control from the main Vipersat
Configuration menu. When using the Parameter Editor, click on DPC from the
tree list.
As can be seen, the Maximum Power is display only. The Margin is also display
only, as shown in these two figures. These parameter settings can only be
A p p e n d i x C - D y n a m i c P o w e r C o n t r o l
Table C-2
DPC Parameters, Calculate Max Power Menu
Menu Default
Calculate Calculate
Max Power; Command
Modulator
Calculate Display
Max Power; Only
Modulator
Figure C-3
DPC Configuration screen, CLI
Description
After entering all maximum budgetary settings,
this menu command will generate the Max
Power value for the modulator.
The calculated modulator maximum Power at all
maximum settings (Data Rate, Code Rate,
Modulation, FEC Type). Controls upper limit of
modulator output power.
Configuration
C-9