Chapter 3 - Using The Command Line; Appendix A - Network Addressing; Appendix B - Automatic Switching; Appendix C - Dynamic Power Control1-2 - Comtech EF Data Vipersat CDM-570 User Manual

H o w t o U s e T h i s M a n u a l
Chapter 3 — Using the Command Line Interface (CLI)
Describes the use of the CLI for configuring and monitoring the CDM-570/
570L in a Vipersat network. Each CLI screen is presented along with a detailed
description and related commands.
Appendix A — Network Addressing
Supplemental reference information on binary math and network addressing to
assist with integrating the CDM-570/570L into a Vipersat network.
Appendix B — Automatic Switching
Supplemental reference information on the Vipersat feature that provides Load
switching (response to network traffic load), Application switching (response to
traffic type) functions, and Entry Channel Mode switching functions.
Appendix C — Dynamic Power Control
A description of Vipersat's DPC and its relationship to a CDM-570/570L
configuration.
Appendix D — ECM Migration
Procedural instructions on migrating a Vipersat network of CDM-570/CDD-
56X series equipment from STDMA Entry Channel Mode (ECMv1) to
Dynamic Entry Channel Mode (ECMv2).
Appendix E — Glossary
A glossary of terms that pertain to Vipersat satellite network technology.

Conventions and References

The following conventions are utilized in this manual to assist the reader:
Note: Provides important information relevant to the accompanying
NOTE
text.
Tip: Provides complementary information that facilitates the
associated actions or instructions.
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e
1-2