I n i t i a l C o n f i gu r a t i o n
5.
Hub
Hub Expansion
Remote
Remote Expansion
6.
Set the IP Address
1.
2-6
When the reboot is completed, return to the Feature Configuration screen
and configure the settings for Vipersat STDMA and Auto Switching
according to the table below.
Table 2-2
Unit Role
Save the settings to flash by entering S at the command prompt.
From the Main Menu, enter I to access the Interface Configuration menu
screen, then enter E to access the Ethernet Interface screen, as shown in
figure 2-6.
Figure 2-5
Working Mode dialog
Vipersat Feature Configuration
Vipersat
STDMA
Enabled
(optional) Enabled
Enabled
Disabled
Enabled
(optional) Enabled
Enabled
Disabled
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e
Auto Switching
(optional) Enabled
Disabled
(optional) Enabled
Disabled