Dpc Enabled; Figure 3-51 Dpc Configuration Screen; Figure 3-52 Dpc Configuration Screen - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o n f i g u r a t io n
Figure 3-51
DPC Configuration screen (STDMA mode)
Figure 3-52
DPC Configuration screen (SCPC mode)
Note: The following descriptions will refer to the CDM-570/570L as
NOTE
either modulator or demodulator for simplicity and understanding.
Before enabling DPC, the operator should verify that a demodulator at another
terminal is receiving from this modulator, and that there is a working communi-
cations channel from that receiving station back to the modulator terminal
(inband communications). Additionally, since DPC controls potentially the full
power range of the modulator's output power, it is recommended that the termi-
nal be commissioned and calibrated before usage.

DPC Enabled

The DPC Enabled command (enter E) is a toggle that allows the DPC feature
to be either Enabled or Disabled. The CDM-570/570L is shipped with the DPC
Enabled menu item turned off (Disabled) to allow entrance link levels calibra-
tion during terminal setup.
C h ap t e r U s i n g t h e C o m m a n d L i n e I n t e r f a c e ( C L I )
3 - 3-39