Vipersat Migration; Udp Port Base Address; Figure 3-94 Vipersat Migration Prompt; Figure 3-95 Udp Port Base Address Prompt - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o n f i g u r a t io n

Vipersat Migration

The Vipersat Migration command is used to set the compatibility mode for the
Hub Burst Controller when conducting a firmware upgrade on the associated
CDM-570/570L Remotes. Although this command appears in the menu for both
the Hub modem and the Remote modem, it only applies to STDMA Controllers
and TDM Outbound modems at the Hub.
Enter M at the command prompt in the Vipersat Configuration screen to
display the Vipersat Migration dialog shown in figure 3-94.
Figure 3-94 Vipersat Migration prompt

UDP Port Base Address

Should a particular network application require a specific UDP port base
address be used, the default address can be changed by entering U at the
command prompt in the Vipersat Configuration screen (figure 3-6).
Figure 3-95
UDP Port Base Address prompt
C h ap t e r U s i n g t h e C o m m a n d L in e I n t e r f a c e ( C L I )
3 - 3-69